Compatibility List

Network

Supported

Additional Requirements

P2 RS-485

Y

RS-485 networks can be connected using AEM; however, direct connection is not supported.

P2 AEM

Y

Requires one of the following:

Physical AEM device

Virtual AEM in a PXC

P2 Ethernet

Y

Supported as is.

P2 Dial-Up

X

Not supported. Must be converted to Ethernet network or AEM.

BACnet IP

Y

Supported as is.

ALS3

X

Not supported.

Hardware

Type

ALN

MBC Power Open Processor (562-001,002,040)

MBC Open Processor

MEC Power Controller (549-600 series)

MEC Controller

PXC Compact

PXC Modular

Hardware

Type

FLN P1

P1DXR

TEC

LAB Controllers

Point Expansion Modules

PXC Compact on P1

P1 BIM

Digital Energy Monitor

P1 Drivers

VFD

Hardware

Type

FLN BACnet

DXR (APOGEE Firmware Revision 3.4 and later)

PTEC

PXC UEC

PPM

Hardware

2.x P2 RS-485

2.x P2 Ethernet

3.x BACnet

PXC/PXC-M

2.8.10 and later

2.8.10 and later

3.2.4 and later

PXC/PXC-M Integration Drivers

2.8.2 or 2.8.5

2.8.2 or 2.8.5

3.1 Ver. 2 to (Select 3.5.7)

Power Open Processor

2.8.10 and later

2.8.10 and later

Limited Support*

Power Open Processor Drivers

2.7

2.7

Limited Support*

Pre Power OP

2.8

N/A

N/A

Pre Power OP Drivers

Not Supported

N/A

N/A

Power MEC (V3)

2.8.10 and later

2.8.10 and later

Limited Support*

Power MEC (V3) Drivers

2.7

2.7

Limited Support*

Pre Power MEC (68302)

2.8.10 and later

N/A

N/A

Pre Power MEC Drivers

Not Supported

N/A

N/A

SCU v5

Not Supported

N/A

N/A

FLNC

2.8

2.7

N/A

* will look like a third–party BACnet device.